Single-cylinder hydraulic cone crusher is a kind of efficient crushing equipment, which is widely used in mining, construction, road construction and other fields. However, during use, single-cylinder hydraulic cone crusher may have various faults, affecting its normal operation and production efficiency. Xingaonai will introduce the common faults and solutions of single-cylinder hydraulic cone crusher.
Single-cylinder cone crusher may leak oil during use. Common oil leakage locations include bearings, seals, etc. The cause of oil leakage may be aging of seals or cracks in the casing. It is necessary to disassemble and check the seals and replace or weld the casing. Regularly check and replace the leaking parts to maintain normal lubrication of the equipment.
Single-cylinder hydraulic cone crusher may cause deterioration of crushed material quality due to aging of equipment, improper maintenance and other reasons during long-term use. The solution is to strengthen the maintenance and maintenance of the equipment, regularly check the working status of the equipment, and replace severely worn parts in time.
Blocking of the crusher discharge port is also a common fault. Generally speaking, this problem should be solved from the feed port. If the feed volume is larger than the upper limit or the stone with high water content is used, the crusher discharge port may be blocked. At this time, you only need to adjust the feed volume of the crusher.
When the crusher is difficult to start, it is likely that there is a problem with the motor starting capacitor. At this time, it is necessary to replace the capacitor or adjust the tightness of the motor drive belt. If it has not been solved, it is necessary to further check the transmission and other connecting parts.
The transmission system of the single-cylinder hydraulic cone crusher may fail, such as gear wear and bearing damage. These failures will affect the normal operation of the equipment and even endanger the safety of the operator. The solution is to strengthen the maintenance and maintenance of the transmission system, regularly check the working status of gears, bearings and other components, and replace severely worn parts in time.
When the single-cylinder hydraulic cone crusher has been used for a long time, it may cause rotor wear. At this time, the rotor needs to be disassembled and inspected. If the rotor is found to be severely worn, it needs to be replaced. In addition, if the crusher has not been used for a long time, dust may accumulate on the rotor surface, resulting in increased wear, and the rotor needs to be cleaned and maintained.
The power supply of the single-cylinder hydraulic cone crusher may fail, such as power outage, unstable voltage, etc. This usually causes great damage to the equipment. The solution is to check the working status of the power line and the equipment to ensure that the power supply is stable and reliable.
During the use of the single-cylinder cone crusher, the pressure plate may loosen, which may cause abnormal noise, obvious vibration and other adverse effects.
Regularly check whether the fixing screws of the pressure plate are loose or damaged, and replace and fix them in time.
Notes:
(1. Before use, check whether the machine has abnormal noise or abnormal vibration.
(2. Check the lubrication of the machine frequently. If the lubrication is poor or the lubricant is missing, add or replace the lubricant in time.
(3. During use, pay attention to regular inspection and replacement of wearing parts to extend the service life of the machine.
(4. Clean the feed and discharge ports in time to prevent accumulation.
In short, a single-cylinder cone crusher may have a variety of faults during use, including wear, oil leakage, difficulty in starting, poor discharge, loose power supply and pressure plate, etc. In the normal use of the crusher, be sure to check the lubrication condition and wearing parts of the equipment to ensure the normal operation of the equipment. At the same time, it is also necessary to strengthen maintenance and extend the service life of the equipment.
specialized in R&D and manufacturing of crushing, milling, screening, feeding, conveying, automation and other equipment.
